News
Your location:home>>king combination nipple>>news1>>detail

Last:the right install method is very important to the king combination nipple Next:how to avoid the king combination nipple disclosing?

do you know how to install the king combination nipple in a right way?

Source： Notetime： 2014-06-20 09:28:15 click： 2529

　　The first step is that: you should according to your actual requirement to confirm the length of the king combination nipple , if the length is too long, you should using some professional tools or machines to cutting down; after you had cutting down, you should clean it first, until you make sure that there are no burr, metal chip or dirt on the nipple surface;

　　The second step is that you should using some nuts and cutting ferrules to fixed the king combination nipple , but to ensure the nipple has a good sealing performance, we suggest that you should leave out more than 3mm distance between the pipe end; then put the pipes into the joint taper inner body hole, until you make sure that the pipe end had touched with the inner bore taper, then stopping putting;

　　The next step is to using a suitable strength to tighten the nuts, to prevent some damage of the king combination nipple , you should be very carefully to tighten the nuts, the speed should be very slowly; then turning the pipes at the same time, until you found that the pipes can not move then stopped, then tighten the nut for one circle;

　　The last step: you should tear down the cutting ferrule to make sure that there had cut into the pipe, then according to the draw, to make sure the pipes was been installed in a right condition; the cutting ferrule can not have the axial movement, but can be slight rotation.
 

from：http://www.bauercoupling.com/newsd-nid-242.html