How should the torque limited hydraulic cam and groove coupling be sequentially filled?

　　The filling sequence of the torque limited hydraulic coupler is as follows

　　(a) screw off oil plug of the torque limited hydraulic coupler, two plugs are all unscrewed, couple of gas a gas.

　　(b) the accurate oil filling quantity for the torque limited hydraulic coupler according to the methods described above to determine the number of working fluid filling

　　(c) 80 ～ 100 mesh strainer after working liquid injection coupler cavity with liquid filling, while filling while rotating the coupling spindle, prevent cavity memory gas liquid charge does not go situation.

　　(d) screw on the oil filler plug of the torque limited hydraulic coupler, pay attention not to plug type O ring or gasket damaged. If the damage to the timely replacement of O ring.

　　(E) test liquid filled correctness, check the correct filling quantity according to the "liquid filling validation" method as the 294 question is described

　　(f) calibration liquid filling scale or liquid filling angle overflow liquid, measure and record the coupling liquid filling angle or liquid filling port to the base height.

　　(g) operation screw on the oil filler plug drive operation, observe the oil filler plug has no leakage phenomenon, and try to eliminate

The latest news:
The torque limited hydraulic cam and groove coupling has Light load start energy-saving and is to reduce the capacity of motor energy saving
What will happen if hydraulic cam and groove coupling charging is too much ?
How to determine the filling quantity of fluid cam and groove coupling?
What is the relationship between filling rate and transmission power of the torque limited hydraulic cam and groove coupling?
The importance of the properly fluid filling of hydraulic cam and groove coupling